Parking Aid Rear Sensor 1 Left Corner Circuit
Table of contents
B0958 SATURN Possible Causes
- Faulty Parking Aid Rear Sensor 1 Left Corner
- Parking Aid Rear Sensor 1 Left Corner harness is open or shorted
- Parking Aid Rear Sensor 1 Left Corner circuit poor electrical connection
How do I fix code B0958 SATURN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- B0958 01 Parking Aid Rear Sensor 1 Left Corner Circuit Short to Battery
- B0958 06 Parking Aid Rear Sensor 1 Left Corner Circuit Short to Ground or Open
- B0958 08 Parking Aid Rear Sensor 1 Left Corner Circuit Signal Invalid
- B0958 21 Parking Aid Rear Sensor 1 Left Corner Circuit Incorrect Period
Cost of diagnosing the B0958 SATURN code
The cost of diagnosing the B0958 SATURN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B0958 SATURN Description
The object alarm detection system senses how close the vehicle is to an object. The distance is determined by the 4 ultrasonic sensors located in the rear bumper. The object detection system will notify the driver when backing up at speeds less than 8 km/h (5 mph), which make parking easier and helps you avoid colliding with objects such as parked vehicles. Each object sensor is a 3-wire sensor that is both a transmitter and a receiver that comprises a signal circuit, a low reference circuit, and an 8-volt supply voltage circuit. The rear object control module supplies 8 volts to the object sensors via the object sensor supply voltage circuit and provides ground via the low reference circuit. The rear object control module triggers the sensors in a sequential loop and after each sensor transmits, the rear object control module uses the echo or signal return to calculate the distance and position of an object from the rear bumper. The rear object control module directly controls the Rear Parking Assist (RPA) display. The RPA consists of 2 amber and one red LED that indicates the range of an object from the rear bumper. The rear object control module will also use an audible warning by sending a low speed GMLAN message to the radio.