1st Row Driver Seat Belt Sensor Circuit Shorted Together
Table of contents
B1B53 MITSUBISHI Possible Causes
- Faulty Driver Seat Belt Buckle Switch
- Driver Seat Belt Buckle Switch harness is open or shorted
- Driver Seat Belt Buckle Switch circuit poor electrical connection
- Faulty Occupant Restraint Controller (ORC)
How do I fix code B1B53 MITSUBISHI?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B1B53 MITSUBISHI code
The cost of diagnosing the B1B53 MITSUBISHI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
This Diagnostic Trouble Code (DTC) sets when the Occupant Restraint Controller (ORC) detects the Driver Seat Belt Switch Sense circuit is shorted to ground or the seat belt switch and seat belt ground circuits become shorted together for more than 2.5 seconds. This DTC transitions from active to stored when the module sees a recovery from the shorted together condition for greater than five seconds.
Possible Symptoms
- Air Bag Warning Light ON
B1B53 MITSUBISHI Description
When powered, the Occupant Restraint Controller (ORC) sends a test current across the Driver Seat Belt Buckle Switch circuits every 100 ms to verify the integrity of the switch and wiring. The DTC will set if the circuits are shorted together for 2.5 seconds and the code will transitions from active to stored when the current returns to normal range for five seconds. The front seat belt switches cannot be adjusted or repaired and, if ineffective or damaged, the entire front seat belt buckle-half unit must be replaced. The airbag warning lamp will display in the instrument cluster for this fault. The ORC monitors the status of the seat belt switch circuits at power up and every 100 ms thereafter while the ignition is in on.