Right Side Satellite Acceleration Sensor 1 Internal
Table of contents
B1B75 JEEP Possible Causes
- Faulty Right Side Impact Sensor 1
- Right Side Impact Sensor 1 harness is open or shorted
- Right Side Impact Sensor 1 circuit poor electrical connection
- Faulty Occupant Restraint Controller (ORC)
How do I fix code B1B75 JEEP?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B1B75 JEEP code
The cost of diagnosing the B1B75 JEEP code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
This Diagnostic Trouble Code (DTC) sets when the Occupant Restraint Controller (ORC) receives notification of a self test failure within the impact sensor. Once set, this DTC is latched for the entire ignition cycle or until the clear faults command is used by the scan tool, depending on the specific condition that sets the DTC.
Possible Symptoms
- Air Bag Warning Light ON
B1B75 JEEP Description
The Right Side Impact Sensor 1 is in the B-pillar area just past the first row doors. The impact sensors perform their own self-test using power supplied by the Occupant Restraint Controller (ORC) then communicate this status back to the ORC with periodic updates. Impact sensors perform the self-test for internal circuitry at power up during the initialization process, and continuously through the ignition cycle every 10 ms.