Passenger Seat Weight Sensor 3 Left Front Input Circuit Low
Table of contents
B1B79 JEEP Possible Causes
- Faulty Left Front Passenger Seat Weight Sensor
- Left Front Passenger Seat Weight Sensor harness is open or shorted
- Left Front Passenger Seat Weight Sensor circuit poor electrical connection
- Faulty Occupant Classification Module (OCM)
How do I fix code B1B79 JEEP?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B1B79 JEEP code
The cost of diagnosing the B1B79 JEEP code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Air Bag Warning Light ON
B1B79 JEEP Description
If the module detects that the sensor input is less than 3.4 +/- 0.6% of the Seat Weight Sensor 5 Volt circuit voltage. This Diagnostic Trouble Code (DTC) will also set if the Seat Weight Sensor 5 Volt circuit is shorted to ground. However, this condition would prevent communication with the Occupant Classification Module (OCM) and cause a Lost Communication With OCM DTC to set in other modules. Also, this DTC will remain active after the condition that set this fault is no longer present. This condition is referred to as latching the DTC for the ignition cycle. Cycling the ignition key will change the status from active to stored if the condition that set the fault is no longer present.