Adjustable Pedal Sensor Circuit Low
Table of contents
B1D56 JEEP Possible Causes
- Faulty Adjustable Pedal Sensor
- Adjustable Pedal Sensor harness is open or shorted
- Adjustable Pedal Sensor circuit poor electrical connection
- Faulty Memory Seat Module (MSMD)
How do I fix code B1D56 JEEP?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B1D56 JEEP code
The cost of diagnosing the B1D56 JEEP code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B1D56 JEEP Description
The Adjustable Pedals Switch is located on the left side trim of the drivers seat cushion. Fore and Aft movement of the paddle-type switch allows front-to-rear travel of the adjustable pedals, up to approximately 76 mm (3 inches) total movement. Pushing the paddle forward moves the peddles away from the driver and vice-versa. Movement stops when the switch is released. The switch actuates the electric motor-driven adjustable pedals mechanism through the Memory Seat Module (MSM). MSM logic prevents pedal adjustment while the speed control is set and when the transmission is in Reverse. The Diagnostic Trouble Code (DTC) will set when the Memory Seat Module (MSMD) detects a low signal circuit voltage that is not within voltage specification from the Adjustable Pedal Sensor.