Seat Rear Vertical Position Sensor Circuit Low
Table of contents
B1D75 JEEP Possible Causes
- Faulty Seat Rear Vertical Position Sensor
- Seat Rear Vertical Position Sensor harness is open or shorted
- Seat Rear Vertical Position Sensor circuit poor electrical connection
- Rear Driver Vertical Seat Adjuster Motor
- Faulty Memory Seat Module
How do I fix code B1D75 JEEP?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B1D75 JEEP code
The cost of diagnosing the B1D75 JEEP code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B1D75 JEEP Description
The power seat system receives battery current through a 50 amp fuse in the Power Distribution Center (PDC) so that the power seats remain operational, regardless of the ignition switch position.
When a power seat switch is actuated, a battery feed and a ground path are applied through the power seat switch contacts to the appropriate motor or motors. The motor and drive unit operate to move the seat in the selected direction until the switch is released, or until the travel limit of the power seat track is reached. When the switch is moved in the opposite direction, the battery feed and ground path to the motor is reversed through the switch contacts. This causes the motor to run in the opposite direction.
When the seat motor is activated sensor supply voltage is switched on whenever motor is activated. If sensor voltage is not within a specified range this Diagnostic Trouble Code (DTC) will set. This DTC will only set when the seat switch is moved in the same direction three consecutive times.