Rear Washer Switch Stuck
Table of contents
B232E RAM Possible Causes
- Faulty Multifunction Switch
- Multifunction Switch harness is open or shorted
- Multifunction Switch circuit poor electrical connection
How do I fix code B232E RAM?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B232E RAM code
The cost of diagnosing the B232E RAM code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B232E RAM Description
The Wiper/Washer Switch is integral to the Multifunction Switch. The Multifunction Switch is connected to the left side of the Clockspring/SAS. The Multifunction switch provides the primary controls for the front wiper/rear wiper/washer systems, turn signals and for headlamp high beam selection. The Multifunction Switch communicates with the Steering Angle Sensor (SAS) (integral to the Steering Column Control Module) via the LIN Bus. The SAS then converts this data to a CAN Bus signal and broadcasts the message to the corresponding module on the bus.