Door Not Pulled To Primary During Power Close And High Duty Cycles
Table of contents
B2592 LINCOLN Possible Causes
- Power Sliding Door (PSD) Adjustment
- Low Battery Voltage
How do I fix code B2592 LINCOLN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B2592 LINCOLN code
The cost of diagnosing the B2592 LINCOLN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B2592 LINCOLN Description
While the Power Sliding Door (PSD) is closing and the PSD detent switch ground signal on the circuit is received, the PSD module supplies full power to the PSD motor to completely close and latch the power sliding door. As the power sliding door is powered to the final latch position, another momentary ground signal is received by the PSD module on the circuit. When a second momentary ground is detected, signifying the primary latch position (power sliding door completely latched), power is removed from the drive assembly actuator clutch and motor. If the PSD module does not receive the second ground signal from the PSD detent switch on circuit, and after full power has been applied to the PSD motor for 1 second, DTC B2592 sets.