No Movement Was Detected After An Unlatch During A Power Open
Table of contents
B2594 LINCOLN Possible Causes
- Faulty Power Sliding Door (PSD) Detent Switch
- Faulty Power Sliding Door (PSD) Drive Assembly Actuator
- Faulty Power Sliding Door (PSD) Module
How do I fix code B2594 LINCOLN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B2594 LINCOLN code
The cost of diagnosing the B2594 LINCOLN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B2594 LINCOLN Description
The Power Sliding Door (PSD) Module supplies 12 volts to the latch actuator on a circuit through the sliding door contacts which release the power sliding door latch. Also, a 5-volt reference is supplied to the position sensor on circuit. The PSD detent switch circuit is monitored for a momentary ground signaling the rear latch is released. This circuit is monitored through the sliding door contacts and will open when the contacts separate. When the momentary PSD detent switch ground is detected by the PSD module, power is supplied to the drive assembly actuator clutch and motor which opens the power sliding door. As the power sliding door is opened, the position sensor is used to track the power sliding door movement and position. If there is no movement detected by the PSD module after an unlatch occurred, DTC B2594 sets.