Driver Differential Temperature Fault
Table of contents
B272C LINCOLN Possible Causes
- Restricted Driver Cushion or Backrest Blower Motor Filter
- Faulty Driver Cushion or Backrest Blower Motor
- Driver Cushion or Backrest Blower Motor harness is open or shorted
- Driver Cushion or Backrest Blower Motor circuit poor electrical connection
- Faulty Seat Control Module E (SCME)
How do I fix code B272C LINCOLN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B272C LINCOLN code
The cost of diagnosing the B272C LINCOLN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B272C LINCOLN Description
The Seat Control Module E (SCME) is supplied voltage at all times, but the climate controlled seat system only operates with the engine running. The system can be operated with the ignition ON engine OFF by using a scan tool to bypass the climate controlled seat buttons on the touchscreen interface. When commanding a heat or cool mode operation in this manner, the climate controlled seat system only operates in 15 second intervals. Both voltage supply circuits are spliced together internal to the SCME, so if one circuit becomes open, both seats can still be operated. However, if a fault occurs setting a DTC specific to either climate controlled seat, only the affected seat is disabled by the SCME.
Cabin air is drawn through and distributed to each of the blower motors located in the seat cushion and backrest. The blower motors then heat or cool the air. The air is then directed into the foam pad where it is distributed along the surface of the cushion and backrest of the seat. Once the system is activated, the SCME uses a set of flexible algorithms to control the heating/cooling modes and the blower speed dependant on the commanded climate controlled seat settings.
A differential fault occurs when the cushion and backrest blower motors on an affected seat are reporting very different temperatures to the SCME. This may result from an airflow restriction or a circuit fault of either blower motor area. If a blower motor is clear of obstruction and is operational, check the other blower motor and circuitry on the seat. It is important to note that a blower motor with a higher temperature may be operating correctly and not the area of concern. The other blower motor may be indicating a much lower temperature, causing the Diagnostic Trouble Code (DTC) to set.
If there is a temperature differential between the driver backrest and cushion blower motor of 60 ° C (108 ° F) or more for more than 4 seconds, the blower motor is disconnected or the duct is blocked, this DTC sets. When this happens the first time in a key cycle, the SCME puts the driver seat system into recovery mode (see principles of operation). If the system is able to recover, it functions normally. If the system is able to recover and it occurs a second time in the same key cycle, the SCME shuts down the driver seat system.