PASS-Key Programming Mode Active
Table of contents
B2735 GMC Possible Causes
- Faulty Body Control Module (BCM)
- Body Control Module (BCM) harness is open or shorted
- Body Control Module (BCM) circuit poor electrical connection
How do I fix code B2735 GMC?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B2735 GMC code
The cost of diagnosing the B2735 GMC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B2735 GMC Description
The Body Control Module (BCM) supplies a 5 volt signal and a ground circuit for the PASS-Key® system. This allows the BCM to detect PASS-Key® resistance values. Inserting the PASS-Key® (with resistor pellet) in the ignition lock cylinder completes the PASS-Key® circuit. Contacts in the ignition lock cylinder mate with the pellet contacts. The BCM compares the resistance value of the key pellet to the valid resistance programmed into the BCM. If the proper resistance value is read, the BCM allows the following functions to occur: The theft deterrent relay to energize, The steering column to unlock and The BCM sends a message through the serial data line to the powertrain control module (PCM) to enable fuel delivery. When a BCM is replaced, the BCM must be programmed to accept the resistance value of the existing vehicle keys in order to allow PASS-Key® operation. When the BCM is replaced, the service replacement BCM is programmed to accept the first PASS-Key® resistance value detected. If the BCM is unable to detect a valid PASS-Key® resistance value, the BCM will never end the programming sequence and DTC B2735 will set.