No transmitters Programmed
Table of contents
B2805 CADILLAC Possible Causes
- Program transmitters
- Faulty Remote control door lock receiver
- Remote control door lock receiver harness is open or shorted
- Remote control door lock receiver circuit poor electrical connection
How do I fix code B2805 CADILLAC?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B2805 CADILLAC code
The cost of diagnosing the B2805 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B2805 CADILLAC Description
When a receiver is replaced, all transmitters must be programmed to a new electronic door lock receiver. DTC will remain current until at least one transmitter is programmed. Up to 3 identification codes can be stored by the receiver.
The Diagnostic Trouble Code (DTC) B2805 will set and store in receiver memory when the electronic door lock receiver indicates no transmitter Vehicle Access Code (VAC) has been programmed. No driver warning message will be displayed for this DTC.
The DTC B2805 will automatically clear when the electronic door lock receiver has indicated a valid VAC was programmed properly.