Rain Sensor Mode Control Circuit
Table of contents
B370D SATURN Possible Causes
- Faulty Windshield Outside Moisture Sensor (Rain Sensor)
- Windshield Outside Moisture Sensor harness is open or shorted
- Windshield Outside Moisture Sensor circuit poor electrical connection
- Faulty Body Control Module (BCM)
How do I fix code B370D SATURN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the B370D SATURN code
The cost of diagnosing the B370D SATURN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B370D SATURN Description
Ignition voltage is supplied to the windshield outside moisture sensor from the Body Control Module (BCM). Whenever the ignition is in the run or accessory positions, the BCM sends the wiper/washer switch status using a Pulse Width Modulated (PWM) signal through the windshield outside moisture sensor signal 1 circuit to the outside moisture sensor. When a wipe cycle is needed, the moisture sensor sends a PWM voltage signal through the moisture sensor signal 2 circuit back to the BCM requesting the wiper operation.
The windshield outside moisture sensor uses the moisture sensor signal 2 circuit to command wiper motor wipe cycles and to confirm the moisture sensor signal 1 is being received. If at anytime communication between the windshield outside moisture sensor and BCM is lost, the BCM will use the inputs from the windshield wiper/washer switch in the delay positions to operate the wiper motor at continuous variable delay intervals.
The Diagnostic Trouble Code (DTC) sets if an open, short to ground or a short to voltage has been detected on the moisture Sensor Signal 1 circuit.