Rear Right Wheel Speed Sensor Invalid Or No Signal
Table of contents
C1211 HYUNDAI Possible Causes
- Improper installation of wheel speed sensor
- Abnormal Rotor and wheel bearing
- Faulty Rear Right Wheel Speed Sensor
- Rear Right Wheel Speed Sensor harness is open or shorted
- Rear Right Wheel Speed Sensor circuit poor electrical connection
How do I fix code C1211 HYUNDAI?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the C1211 HYUNDAI code
The cost of diagnosing the C1211 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Anti-Lock Brake System (ABS) Warning Light ON
C1211 HYUNDAI Description
The Wheel Speed Sensor is the essential component the Anti-Lock Brake System (ABS) ECU uses to calculate vehicle speed and to determine whether wheel lock occurs. For example, a rear-wheel speed signal is used as a reference value, for vehicle speed, in front-wheel drive vehicles, and if a difference between the front and rear wheel speed occurs, then ABS control is performed. The wheel speed sensor generates sinewave signals, based on a magnetic field made by a permanent magnet in the speed sensor when the tone wheel rotates. The ABS ECU monitors the wheel speed sensor signal continuously. This code is set when there is no wheel speed signal within 10ms to 20ms at a vehicle speed > 43.2 km/h (26.8 mph) or a deviation between sensors exceed the threshold or one or two wheels are at 2.75 km/h (1.7 mph) while the vehicle speed is at 12 km/h (7.5 mph). The warning lamp is turned OFF unless additional faults are detected when the IG KEY has turned ON again, and wheel speed is more than 12 Km/h (7.5 mph).