Trailer Brake Output Circuit Short To Overload
Table of contents
C2808 MERCURY Possible Causes
- Faulty Trailer Brake Control (TBC) Module
- Trailer Brake Control (TBC) Module harness is open or shorted
- Trailer Brake Control (TBC) Module circuit poor electrical connection
How do I fix code C2808 MERCURY?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the C2808 MERCURY code
The cost of diagnosing the C2808 MERCURY code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Anti-Lock Brake System (ABS) Warning Light ON
- Engine Light ON (or Service Engine Soon Warning Light)
C2808 MERCURY Description
The braking energy that is provided to the trailer is varied with a Pulse Width Modulated (PWM) signal along the circuit that switches between 0 volt and battery voltage, the higher the duty cycle the more braking power available. The Trailer Brake Control (TBC) Module varies the PWM signal based on various inputs such as the brake pressure transducer, TBC module manual slider switch and the TBC module gain buttons. With the vehicle stationary and with the manual slider switch fully to the left with a gain of 10, there should be greater than 10-12 volts supplied to pin 3 of the 7-pin trailer tow connector. Every 4 seconds the TBC module sends a voltage pulse along circuit CAT19 (BU) to pin 3 of the 7-pin trailer tow connector to determine whether or not a trailer is connected.