Air-Fuel Ratio Sensor Heater Control Circuit High 21
Table of contents
P0052 TOYOTA Possible Causes
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 2 Sensor 1
- Air-Fuel Ratio (A/F) Sensor Bank 2 Sensor 1 harness is open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 2 Sensor 1 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How do I fix code P0052 TOYOTA?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P0052 TOYOTA code
The cost of diagnosing the P0052 TOYOTA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
The P0052 is set when the Engine Control Module (ECM) detects an excessively High voltage through the heated oxygen sensor heater circuit
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0052 TOYOTA Description
Air-Fuel Ratio (A/F)sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. The faster the air-fuel ratio sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
Hi my car hesitates and runs sluggish only on hot sunny days..at night or when it’s raining it drives perfect..I did a scan and got a code p0052 I changed the o2 sensor upstream and checked the wire harness which is all good but the scan is still giving me the p0052 but the funny thing is there’s no check engine light before I replaced the sensor and even after..maybe I got a bad ECM cause another check showing a ECM battery issue..plz help