Fuel Pump Control Circuit Open
Table of contents
P025A DODGE Possible Causes
- Faulty Fuel Pump Control Module (FPCM)
- Fuel Pump Control Module (FPCM) Harness is open or shorted
- Fuel Pump Control Module (FPCM) circuit poor electrical connection
How do I fix code P025A DODGE?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P025A DODGE code
The cost of diagnosing the P025A DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P025A DODGE Description
When the Powertrain Control Module (PCM) receives a ‘Start’ or ‘Run’ signal from the ignition; It energizes the Fuel Pump relay which sends a continuous 12 volt supply to the Fuel Pump Control Module (FPCM). The PCM also sends a control signal directly to the FPCM which regulates the Pulse Width Modulated (PWM) voltage that will be sent to the Fuel Pump Module. The PWM will vary from 10-100% depending on the input of the Fuel Rail Pressure sensor and other engine demands. The Powertrain Control Module (PCM) receives a Pulse Width Modulated (PWM) signal from the Fuel Pump Control Module (FPCM) representing the state of all inputs and outputs of the FPCM. This is a Constant Pressure Fuel system which means any Delta Pressure test performed on the Fuel Pump would show a continuous pressure (regardless of the changes in PWM). If a pressure sensor fails or other failures are present; The duty cycle goes to Limp mode (100%) to maintain fuel pressure.