Knock Sensor Circuit Malfunction
Table of contents
- Possible Causes
- How To Fix
- Tech Notes
- Cost To Diagnose
- When is the code detected
- Possible Symptoms
- Description
P0325 MAZDA Possible Causes
- Faulty Knock Sensor
- Knock Sensor circuit poor electrical connection
- Knock Sensor harness is open or shorted
- Faulty Engine Control Module (ECM)
How do I fix code P0325 MAZDA?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- The P0325 code means that the Knock Sensor is not working properly. Problems with the knock sensor will not cause an engine performance problems. Replacing the knock sensor usually takes care of the problem.
Cost of diagnosing the P0325 MAZDA code
The cost of diagnosing the P0325 MAZDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
When an excessively low or high voltage from the sensor is sent to Engine Control Module (ECM)
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible Lack/Loss of Power
P0325 MAZDA Description
The Knock Sensor (KS) senses engine knocking (also known as detonation or pinging) using a piezoelectric element. The sensor is attached to the cylinder block, cylinder head or intake manifold. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the Engine Control Module (ECM). The ECM uses this signal to retard the ignition timing and protect the engine from this damaging pre-ignition.