Engine Oil Pressure Sensor/Switch Circuit Low Voltage
Table of contents
- Possible Causes
- How To Fix
- Tech Notes
- Cost To Diagnose
- When is the code detected
- Possible Symptoms
- Description
P0522 DODGE Possible Causes
- Low oil level or motor mechanical fault
- Faulty Oil Pressure sensor
- Oil Pressure Sensor harness is open or shorted
- Oil Pressure Sensor circuit poor electrical connection
How do I fix code P0522 DODGE?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- There is a factory service bulletin for the following Dodge Models:
- 2011 Dodge Avenger
- 2011 Dodge Caravan
- 2011 Dodge Challenger
- 2011 Dodge Charger
- 2011 Dodge Journey
- Dodge Factory Service Bulletin OBDII Code P0522
- The bulletin recommends reprogramming the Powertrain Control Module (PCM).
Cost of diagnosing the P0522 DODGE code
The cost of diagnosing the P0522 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
The P0522 is detected when the signal sent from oil pressure sensor to PCM goes below specifications.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Oil pressure warning light ON
P0522 DODGE Description
The engine oil pump features seven vanes and a moving element that continuously adjusts to maintain a regulated oil pressure supply by varying the displacement of the pump. The pump has two regulated pressure stages of operation controlled by an on/off solenoid. Low pressure mode regulation (solenoid on) is approximately 200 kPa (29 psi) and high pressure mode regulation (solenoid off) is approximately 450 kPa (65 psi). The Powertrain Control Module (PCM) switches the pump between stages based on engine operating conditions, oil and coolant temperatures, speed and load. Under most typical conditions, the pump will run in low mode from idle up to around 3000 RPM and switch fromlow to high mode between 3000 and 4000 RPM. The maximum oil pressure in the engine is limited to 1000 kPa (145 psi) by the relief valve. Pressure in the main oil gallery of the engine can be monitored with diagnostic equipment through the oil pressure sensor mounted on the rear of the oil filter module. The minimum pressure for the engine is 41 kPa (6 psi) at any operating condition. Anything under this pressure could result in damage to critical moving parts.