Malfunction Indicator Lamp Control Circuit Malfunction
Table of contents
P0650 LAND-ROVER Possible Causes
- Faulty Malfunction Indicator Lamp Bulb
- Malfunction Indicator Lamp Bulb harness is open or shorted
- Malfunction Indicator Lamp Bulb circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How do I fix code P0650 LAND-ROVER?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P0650 LAND-ROVER code
The cost of diagnosing the P0650 LAND-ROVER code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
– An excessively high voltage is sent to Engine Control Module (ECM) through the MIL circuit under the condition that calls for MIL light up.
– An excessively low voltage is sent to ECM through the MIL circuit under the condition that calls for MIL not to light up.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0650 LAND-ROVER Description
Malfunction Indicator Lamp (MIL) is located on the instrument panel. When the ignition switch is turned ON without engine running, MIL will light up. This is a bulb check. When the engine is started, MIL should go off. If MIL remains on, the on board diagnostic system has detected an engine system malfunction.