Drive Motor Coolant Temperature Sensor Circuit Low Voltage


Table of contents

P0CBE BUICK Possible Causes

  • Faulty Starter/Generator Coolant Temperature Sensor
  • Starter/Generator Coolant Temperature Sensor harness is open or shorted
  • Starter/Generator Coolant Temperature Sensor circuit poor electrical connection
  • Faulty Starter/Generator Control Module

How do I fix code P0CBE BUICK?

  Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.

Cost of diagnosing the P0CBE BUICK code

  The cost of diagnosing the P0CBE BUICK code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0CBE BUICK Description

  The hybrid electronics coolant temperature sensor is a variable resistor that measures the temperature of the starter/generator coolant. The Starter/Generator Control Module supplies 5 V to the signal circuit and a ground for the low reference circuit. The hybrid electronics coolant temperature sensor resistance changes with starter/generator coolant temperature. As the temperature decreases, the sensor resistance increases. As the temperature increases, the sensor resistance decreases. The Starter/Generator Control Module monitors the hybrid electronics coolant temperature sensor to determine the temperature of the starter/generator coolant. As the coolant temperature changes, the Starter/Generator Control Module will turn the Starter/Generator Control Module coolant pump ON or OFF to accommodate the starter/generator cooling requirements.
The Starter/Generator Control Module performs a rationality diagnostic that compares the hybrid electronics coolant temperature sensor signal to the average temperature of the starter/generator stator, engine intake air temperature, and transmission fluid temperature. This diagnostic gets one chance to run during a drive cycle after a specific vehicle OFF time.

Leave a Reply

Your email address will not be published. Required fields are marked *