System Diagnosis Incomplete
Table of contents
P1000 KIA Possible Causes
- The vehicle is new from the factory.
- Battery or Powertrain Control Module (PCM) had recently been disconnected.
- An OBD monitor failure occurred before completion of an OBD drive cycle.
- PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool.
How do I fix code P1000 KIA?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P1000 KIA code
The cost of diagnosing the P1000 KIA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
If DTC P1000 is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1000 KIA Description
The On Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.