Intake Camshaft Position Actuator Park Position Bank 1
Table of contents
P1011 SUZUKI Possible Causes
- Low engine oil level
- Low engine oil pressure
- Faulty Intake Camshaft Position Actuator Bank 1
How do I fix code P1011 SUZUKI?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- Before replacing any parts, check engine oil level and condition. Replaced engine oil and filter with factory recommend oil weight if necessary.
Cost of diagnosing the P1011 SUZUKI code
The cost of diagnosing the P1011 SUZUKI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1011 SUZUKI Description
The Camshaft Position (CMP) actuator system enables the Engine Control Module (ECM) to change the camshaft timing of all 4 camshafts while the engine is operating. The CMP actuator assembly varies the camshaft position in response to directional changes in oil pressure. The CMP actuator solenoid controls the oil pressure that is applied to advance or retard a camshaft.
The CMP actuator assemblies have an outer housing that is driven by the engine timing chain. Inside the CMP assembly is a wheel with fixed vanes that is attached to the camshafts. The CMP actuator assemblies are also equipped with a locking pin. The locking pin prevents movement between the outer housing and the wheel vane assembly on engine start-ups. The CMP actuator is locked until sufficient oil pressure is available to control the CMP actuator. The locking pin is released by oil pressure before any movement in the CMP actuator assembly takes place. If the ECM detects that the CMP actuator is not in the locked position on a start-up, this Diagnostic Trouble Code (DTC) sets.