Swirl Control Valve Circuit
Table of contents
P1132 NISSAN Possible Causes
- Faulty Swirl Control Valve
- Swirl Control Valve harness is open or shorted
- Swirl Control Valve circuit poor electrical connection
How do I fix code P1132 NISSAN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P1132 NISSAN code
The cost of diagnosing the P1132 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
An improper voltage signal is sent to Engine Control Module (ECM).
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1132 NISSAN Description
Swirl control valve consists of actuator and valve. The valve is installed in the intake manifold, and the actuator is connected to the rear end of the valve shaft.
The swirl control valve uses a step motor which has four winding phases. It operates according to the output pulse signal of the Engine Control Module (ECM). Two windings are turned ON and OFF in sequence. Each time an ON pulse is issued, the valve opens or closes. When no change in the control position is needed, the ECM does not issue the pulse signal. A certain voltage signal is issued so that the valve remains at that particular opening.