Ignition Control Module Circuit High Voltage
Table of contents
P1351 ISUZU Possible Causes
- Faulty Ignition Control Module
- Ignition Control Module harness is open or shorted
- Ignition Control Module circuit poor electrical connection
How do I fix code P1351 ISUZU?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P1351 ISUZU code
The cost of diagnosing the P1351 ISUZU code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
The Powertrain Control Module (PCM) detects an open in the Ignition Control Module (ICM)
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1351 ISUZU Description
The Ignition Control Module (ICM) has independent power and ground circuits. The circuits between the ICM and the Powertrain Control Module (PCM) consists of the following circuits:
-The ignition control (IC) timing signal
-The IC timing control
-The low resolution engine speed signal
-The medium resolution engine signal
-The camshaft position signal
-The low reference
The ICM sends 3X signals to the PCM, and controls the timing advance during engine cranking. The timing advance changes to PCM control after the following actions occur:
The PCM receives the second 3X signal
The PCM applies 5 volts to the ignition control (IC) timing signal circuit.
The ICM monitors the CKP sync signal when the engine is cranking. The CKP sync signal is passed from the CKP sensor to the ICM on the CKP sensor 2 signal circuit. The CKP sync signal is used to determine the correct cylinder pair and initiate the ignition coil firing sequence. The 18X reference pulses are passed from the CKP sensor to the ICM on the CKP sensor 1 circuit. The 18X reference pulses are used for fuel injection and ignition control. After the ICM receives both signals, the ICM passes the 18X and 3X reference signals to the PCM. The CMP and the CKP sensors share a 12 volt reference and low reference circuit. The CKP sensor consists of the following circuits:
-A 12 volt reference
-A low reference
-A CKP sensor 1 signal
-A CKP sensor 2 signal