Cylinder Position Sensor 1 No Signal
Table of contents
- Possible Causes
- How To Fix
- Tech Notes
- Cost To Diagnose
- When is the code detected
- Possible Symptoms
- Description
P1382 ISUZU Possible Causes
- Cylinder Position Sensor harness is open or shorted
- Cylinder Position Sensor circuit poor electrical connection
- Faulty Cylinder Position Sensor
How do I fix code P1382 ISUZU?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- The Cylinder Position (CYP) Sensor, Crankshaft Position Sensor (CKP) and Top Dead Center (TDC) Sensor are all built into the distributor.
Cost of diagnosing the P1382 ISUZU code
The cost of diagnosing the P1382 ISUZU code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
If no cylinder position (CYP) sensor pulsing signals are detected, a malfunction is detected and a the P1382 code is stored.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1382 ISUZU Description
The cylinder position (CYP) sensor consists of a rotor and a pick-up coil that detects rotor position. When the rotor turns after starting the engine, the changes of magnetic flux in the pick-up coil are converted into pulsing signals to the engine control module (ECM)/powertrain control module (PCM). The CYP sensor detects the position of the No.1 cylinder for sequential fuel injection.