Evaporative Emissions Control System Leakage Fuel Tank


Table of contents

P1456 Possible Causes

  • Missing Fuel cap
  • Incorrect fuel filler cap used
  • Fuel filler cap remains open or fails to close
  • Foreign matter caught in fuel filler cap
  • EVAP purge control solenoid
  • EVAP canister
  • Fuel tank pressure sensor

How do I fix code P1456?

  Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.

Tech Notes

  • Usually, loose or bad fuel tank filler cap will trigger this codes. Retighten fuel tank filler cap and erase code to repair the problem.

Cost of diagnosing the P1456 code

  The cost of diagnosing the P1456 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Possible a noticeable fuel odor caused by the release of fuel vapors

P1456 Description

  The evaporative emission (EVAP) control system stores fuel vapor from the fuel tank in the EVAP canister temporarily to prevent it from escaping to the atmosphere and to enable it to be drawn into the engine by intake manifold vacuum and burned. In addition, the onboard refueling vapor recovery system (ORVR) stores fuel vapor generated when refueling in the EVAP canister.
The EVAP control system leak detection method improves the accuracy and frequency of the detection by determining faulty components and vapor leakage for each part. The EVAP control system (from the purge valve to the fuel tank) is pided into two parts. One is the “EVAP Canister Side” (from the EVAP two way valve to the purge valve) and the other is the “Tank Side” (from the EVAP two way valve to the fuel tank). There is 0.04 inch leak detection and 0.02 inch leak detection. If the 0.04 inch leak detection results are OK, the 0.02 inch leak detection runs.

Related Codes

Leave a Reply

Your email address will not be published. Required fields are marked *