Intake Manifold Runner Control Stuck Closed Bank 2
Table of contents
P1513 MAZDA Possible Causes
- Faulty Intake Manifold Runner Control (IMRC) actuator
- Intake Manifold Runner Control actuator harness is open or shorted
- Intake Manifold Runner Control actuator circuit poor electrical connection
- Faulty Powertrain Control Module (PCM)
How do I fix code P1513 MAZDA?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P1513 MAZDA code
The cost of diagnosing the P1513 MAZDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1513 MAZDA Description
The Intake Manifold Runner Control (IMRC) is an electrically actuated system consisting of a motorized actuator with an attaching linkage for each housing on each bank. The linkage attaches to the housing butterfly plate levers. Each IMRC housing is an aluminum casting with two intake air passages for each cylinder. One passage is always open, and the other is opened and closed with a butterfly valve plate. The housing uses a return spring to hold the plates closed. The motorized actuator houses internal switches to provide feedback to the Powertrain Control Module (PCM), indicating linkage and plate position. Under about 3000 rpm, the vacuum solenoid will be energized. This will allow the manifold vacuum to be applied and the butterfly valve plates to stay closed. Above approximately 3000 rpm, the vacuum solenoid will be de-energized. This will allow a vacuum to vent from the actuator and the butterfly valve plates to open. The Diagnostic Trouble Code (DTC) sets when the IMRC is commanded open, but the IMRC monitor indicates close.