Internal Mode Switch ‘B’ Circuit High Voltage
Table of contents
P182C CHEVROLET Possible Causes
- Faulty Manual Shift Shaft Position Switch Assembly
- Manual Shift Shaft Position Switch Assembly harness is open or shorted
- Manual Shift Shaft Position Switch Assembly circuit poor electrical connection
How do I fix code P182C CHEVROLET?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- The automatic transmission manual shift shaft position switch assembly connects electrically to the control solenoid valve assembly. Inspect the automatic transmission manual shift shaft position switch, harness, connector, and control solenoid assembly pins for metallic debris. Use a terminal test kit for any test that requires probing the control solenoid assembly harness connector or a component harness connector. The automatic transmission manual shift shaft position switch assembly can be damaged by currents exceeding 2 mA. Test the automatic transmission manual shift shaft position switch assembly for an open condition whenever a short to voltage condition is observed.
Cost of diagnosing the P182C CHEVROLET code
The cost of diagnosing the P182C CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P182C CHEVROLET Description
The automatic transmission manual shift shaft position switch assembly, also called the internal mode switch assembly, is a dual sliding hall-effect switch attached to the control valve body within the transmission. The 9 outputs from the switch indicate which position is selected by the transmission manual shaft. Four outputs (A, B, C, P) are range selection inputs to the transmission control module (TCM). Five outputs (R1, R2, D1, D2, S) are direction selection inputs to the hybrid powertrain control module. The input voltage at the modules is high when the switch is open and low when the switch is closed to ground. The state of each input is displayed on the scan tool as Internal Mode Switch A/B/C/P and Internal Mode Switch Status D1/D2/R1/R2/S. The Internal Mode Switch Range input parameters represented are transmission range signal A, signal B, signal C, and signal P. The Internal Mode Switch Direction input parameters represented as Internal Mode Switch Status signal R1, signal R2, signal D1, signal D2, and signal Start.