Gear Position Sensor Circuit 2 High Voltage
Table of contents
P18C7 CHEVROLET Possible Causes
- Faulty Gear Position Sensor
- Gear Position Sensor harness is open or shorted
- Gear Position Sensor circuit poor electrical connection
How do I fix code P18C7 CHEVROLET?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P18C7 CHEVROLET code
The cost of diagnosing the P18C7 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P18C7 CHEVROLET Description
The gear position sensor is a switching transistor mounted to the top of the transmission extension housing. The four wire sensor interfaces directly with the Engine Control Module (ECM). The ECM supplies 5 V to the gear position sensor on a 5 V reference circuit and also provides a ground path on a low reference circuit. The sensor provides a Pulse Width Modulated (PWM) duty cycle to the ECM on two signal circuits that is proportional to the linear and radial position of the corresponding magnet assembly mounted to the shift shaft. The vehicle uses the gear position sensor information primarily for Active Rev Matching and Active Fuel Management. The ECM monitors the linear position signal 2 circuit for low and high voltage conditions.