Starter/Generator Control Module Cooling Fan Relay Control Circuit Low Voltage
Table of contents
P1AC1 CHEVROLET Possible Causes
- Faulty Starter/Generator Control Module Cooling Fan Relay
- Starter/Generator Control Module Cooling Fan Relay harness is open or shorted
- Starter/Generator Control Module Cooling Fan Relay circuit poor electrical connection
How do I fix code P1AC1 CHEVROLET?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P1AC1 CHEVROLET code
The cost of diagnosing the P1AC1 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1AC1 CHEVROLET Description
The Starter/Generator Control Module (SGCM) controls the coolant fan operation by applying voltage to the coolant fan relay control circuit with an internal solid state device called a driver. When the SGCM is commanding the relay ON, the voltage of the control circuit should be low, near 0 volts. When the SGCM is commanding the relay OFF, the voltage potential of the control circuit should be high, near 12 volts.
The SGCM monitors the relay control circuits for the following conditions:
– Short to ground
– Short to voltage
An open circuit
If the SGCM detects an improper voltage level on the coolant fan relay control circuit, then DTC P1AC1 or P1AC2 will set and the driver will be disabled.