All CAN Malfunction Battery Condition Monitor Module – PCM
Table of contents
P1D00 Possible Causes
- Faulty Battery Condition Monitor Module
- Battery Condition Monitor Module harness is open or shorted
- Battery Condition Monitor Module circuit poor electrical connection
How do I fix code P1D00?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P1D00 code
The cost of diagnosing the P1D00 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1D00 Description
The battery control processor is in the battery condition monitor module. The controller area network (CAN) transmits/receives pulsing signals to/from the control modules simultaneously by using two signal lines (F-CAN A_H and F-CAN A_L) and (EPP-CAN_H and EPP-CAN_L). The F-CAN and the EPP-CAN sends same data. If the F-CAN or the EPP-CAN does not transmit/receive data, the normal signal line can transmit/receive data. If the F-CAN and the EPP-CAN does not transmit/receive data, the battery condition monitor module cannot run normally. The battery condition monitor module detects no signal, received data is abnormal or BUS-OFF is received via the F-CAN and EPP-CAN, the battery condition monitor module detects a malfunction and stores a DTC.