Leak Sensor Drive Inhibition Signal Stuck On
Table of contents
P1D62 HONDA Possible Causes
- Faulty Leak Sensor Drive Inhibition
- Leak Sensor Drive Inhibition harness is open or shorted
- Leak Sensor Drive Inhibition circuit poor electrical connection
How do I fix code P1D62 HONDA?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P1D62 HONDA code
The cost of diagnosing the P1D62 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1D62 HONDA Description
There is a high voltage wiring system, including the high voltage battery, in the electric powertrain. The high voltage wiring system is insulated from the body on both positive and negative circuits. The leak sensor stops measuring the short circuit resistance when it receives prohibit drive signal from the battery condition monitor module, and sends it signal via the serial communication to the battery condition monitor module. When the battery condition monitor module sends a to drive signal (drive inhibition signal line: high), the leak sensor sends drive stop signal for a set time, the battery condition monitor module detects a malfunction and stores a DTC.