Intake Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Bank 1
Table of contents
P2089 CADILLAC Possible Causes
- Faulty Intake Camshaft Position Actuator Solenoid Valve Bank 1
- Intake Camshaft Position Actuator Solenoid Valve Bank 1 harness is open or shorted
- Intake Camshaft Position Actuator Solenoid Valve Bank 1 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How do I fix code P2089 CADILLAC?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P2089 CADILLAC code
The cost of diagnosing the P2089 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P2089 CADILLAC Description
The camshaft position actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is operating. The Camshaft Position Actuator Solenoid Valve signal from the ECM is Pulse Width Modulated (PWM). The ECM controls the Camshaft Position Actuator Solenoid Valve duty cycle by controlling the amount of solenoid valve ON time. The Camshaft Position Actuator Solenoid Valve controls the advance or the retard of each camshaft. The Camshaft Position Actuator Solenoid Valve controls the oil flow that applies the pressure to advance or retard the camshafts.
Ignition voltage is supplied directly to the Camshaft Position Actuator Solenoid Valve. The ECM controls the solenoid valve by grounding the control circuit with a solid-state device called a driver. The driver is equipped with a feedback circuit that is pulled-up to a voltage. The ECM can determine if the control circuit is open, shorted to ground, or shorted to a voltage by monitoring the feedback voltage.
The Diagnostic Trouble Code (DTC) will set when the ECM detects a short to voltage in the CMP actuator solenoid circuits for greater than 1 second or a cumulative of 5 seconds, when the solenoid is commanded ON.