Accelerator Pedal Position Sensor Circuit
Table of contents
P2128 NISSAN Possible Causes
- Faulty Accelerator Pedal Position (APP) Sensor
- Accelerator Pedal Position (APP) Sensor harness is open or shorted
- Accelerator Pedal Position (APP) Sensor circuit poor electrical connection
- Faulty Engine Control Module (ECM)
- Electric Throttle Control Actuator(Throttle Body)
How do I fix code P2128 NISSAN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P2128 NISSAN code
The cost of diagnosing the P2128 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected
An excessively low voltage from the APP sensor 2 is sent to ECM.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P2128 NISSAN Description
The Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module (ECM). Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which transform the accelerator pedal position into an output voltage and emit the voltage signal to the ECM. In addition, these sensors detect the opening and closing speed of the accelerator pedal and feed the voltage signals to the ECM. The ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals. Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation such as fuel cut.