Engine Coolant Bypass Valve Range/Performance


Table of contents

P26A3 CADILLAC Possible Causes

  • Faulty Engine Coolant Bypass Valve
  • Engine Coolant Bypass Valve harness is open or shorted
  • Engine Coolant Bypass Valve circuit poor electrical connection

How do I fix code P26A3 CADILLAC?

  Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.

Cost of diagnosing the P26A3 CADILLAC code

  The cost of diagnosing the P26A3 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P26A3 CADILLAC Description

  The passenger compartment heater coolant control valve regulates the engine coolant flow into the cabin heater loop depending on engine coolant temperature and ambient temperature conditions. The passenger compartment heater coolant control valve has two positions: ByPass or Link. In the ByPass position, the coolant in the engine loop and heater loop are separated and in the link position the coolant circulates through both loops. The valve movement is controlled by a PWM signal. A 50% duty cycle is a normal duty cycle. A 75% duty cycle represents a valve commanded to the link position. A 25% duty cycle represents a valve commanded to the ByPass position. The passenger compartment heater coolant control valve uses an internal position sensor that sends a signal to the hybrid powertrain control module to determine the valve position.
When the engine coolant temperature heats up, a valve learn procedure takes place. The hybrid powertrain control module 2 commands the valve to the link position and records the voltage coming back from the position sensor. Then the hybrid powertrain control module 2 commands the valve back to the bypass position and records the voltage coming back from the position sensor. The voltage values in both the link and bypass positions must fall within calibrated ranges.

Leave a Reply

Your email address will not be published. Required fields are marked *