CAN Communication Bus – Signal Malfunction
Table of contents
U1011 NISSAN Possible Causes
- Controller Area Network (CAN) communication harness is open or shorted
- Faulty Engine Control Module (ECM)
- Poor harness ground connection.
How do I fix code U1011 NISSAN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- Nissan has released service bulletins for this problem. A common cause with Nissan vehicles is the poor harness ground connection at the engine compartment and the ground connection behind the dash. Clean and resecure harness ground connection and reset engine light.
Cost of diagnosing the U1011 NISSAN code
The cost of diagnosing the U1011 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
U1011 NISSAN Description
The Controller Area Network (CAN) is a serial communication line for real-time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads the required data only.
The Diagnostic Trouble Code (DTC) sets when detecting errors during the initial diagnosis of CAN controller of the Engine Control Module (ECM).