Electronic Brake Control Module Lost Communication With Engine Control Module
Table of contents
U186A CADILLAC Possible Causes
- Faulty Engine Control Module (ECM)
- Engine Control Module harness is open or shorted
- Engine Control Module circuit poor electrical connection
How do I fix code U186A CADILLAC?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the U186A CADILLAC code
The cost of diagnosing the U186A CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
U186A CADILLAC Description
Modules connected to the Controller Area Network (CAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. The modules have prerecorded information about what messages are needed to be exchanged on the serial data circuits. The messages are supervised and also, some periodic messages are used by the receiver module as an availability indication of the transmitter module. Each message contains the identification number of the transmitter module. A module with a CAN serial data circuits malfunction or which loses power during the current ignition cycle will have a Loss of Communication Diagnostic Trouble Code (DTC) set by other modules that depend on information from that failed module. If any of the CAN circuit are shorted to battery voltage, ground, or between them no communication is possible on the CAN serial data bus, a Diagnostic Trouble Code will set.