Lost Communication With Electronic Brake Control Module


Table of contents

U2108 CADILLAC Possible Causes

  • Faulty Electronic Brake Control Module (EBCM)
  • Electronic Brake Control Module harness is open or shorted
  • Electronic Brake Control Module circuit poor electrical connection

How do I fix code U2108 CADILLAC?

  Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.

Cost of diagnosing the U2108 CADILLAC code

  The cost of diagnosing the U2108 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

U2108 CADILLAC Description

  Modules connected to the Controller Area Network (CAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. The modules have prerecorded information about what messages are needed to be exchanged on the serial data circuits. The messages are supervised and also, some periodic messages are used by the receiver module as an availability indication of the transmitter module. Each message contains the identification number of the transmitter module. A module with a CAN serial data circuits malfunction or which loses power during the current ignition cycle will have a Loss of Communication Diagnostic Trouble Code (DTC) set by other modules that depend on information from that failed module. If any of the CAN circuit are shorted to battery voltage, ground, or between them no communication is possible on the CAN serial data bus, a Diagnostic Trouble Code will set.

Leave a Reply

Your email address will not be published. Required fields are marked *