Roof Stowed Ready to Latch Sensor Circuit
Table of contents
B367F PONTIAC Possible Causes
- Faulty Roof Stowed Ready to Latch Sensor
- Roof Stowed Ready to Latch Sensor harness is open or shorted
- Roof Stowed Ready to Latch Sensor circuit poor electrical connection
- Faulty Folding Top Control (FTC) Module
How do I fix code B367F PONTIAC?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- B367F 58 Roof Stowed Ready to Latch Sensor Circuit incorrect reaction after event
- B367F 59 Roof Stowed Ready to Latch Sensor Circuit circuit/component protection time out
Cost of diagnosing the B367F PONTIAC code
The cost of diagnosing the B367F PONTIAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B367F PONTIAC Description
S13 is the Folding Top Front Location Pin Position switch. The Folding Top Control (FTC) Module uses S13 to determine if the folding top is stored in the rear compartment. S13 closes and pulls the signal circuit low when the folding top is not stored in the rear compartment. The Diagnostic Trouble Code (DTC) sets if an open or short to ground is detected on the control circuit of V1.