Fuel Trim Cylinder Balance Bank 2
Table of contents
P1175 HUMMER Possible Causes
- Clogged Fuel Injectors
- Faulty Oxygen sensor
- Ignition problem
- Fuel injection problem
- Engine mechanical condition
How do I fix code P1175 HUMMER?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- The P1175 code sometimes is triggered by clogged fuel injectors. Start by using high octane fuel and/or fuel additive to clean injectors. If the problem persists fuel injectors may need to be replaced.
- There is a Factory Service Bulletin for the following HUMMER models:
- 2003-2008 HUMMER H2
- 2006-2008 HUMMER H3
- 2003-2008 HUMMER Factory Service Bulletin OBDII Code P1175
Cost of diagnosing the P1175 HUMMER code
The cost of diagnosing the P1175 HUMMER code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1175 HUMMER Description
The Fuel Trim Cylinder Balance diagnostic detects a rich or lean cylinder to cylinder air/fuel ratio imbalance in each bank. The diagnostic monitors the pre-catalyst heated oxygen sensor (HO2S) signal’s frequency and amplitude characteristics by calculating an accumulated voltage over a predetermined sample period. An imbalance is indicated when multiple samples of the accumulated voltage are consistently higher than the desired value.
