Hybrid/EV Battery Interface Control Module 12 Voltage Sensor Circuit High Voltage
Table of contents
P3044 SATURN Possible Causes
- Faulty Hybrid/EV Battery Interface Control Module
- Hybrid/EV Battery Interface Control Module harness is open or shorted
- Hybrid/EV Battery Interface Control Module circuit poor electrical connection
How do I fix code P3044 SATURN?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P3044 SATURN code
The cost of diagnosing the P3044 SATURN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P3044 SATURN Description
The hybrid battery contains 192 inpidual cells. Two cells are welded together in parallel and called a cell group. There are a total of 96 cell groups in the hybrid battery assembly. These cell groups are electrically connected in series. Each inpidual cell group is rated at 3.7 V, for a nominal system voltage of 355 V direct current. The battery cell groups are joined to form 3 distinct sections. The first 24 battery cell groups make up battery section 1. This section is adjacent to the cowl and contains battery cell groups 73 through 96. The next 28 battery cell groups make up battery section 2. This section is located behind section 1 and contains battery cell groups 45 through 72. The transverse battery section is section number 3 and it contains the remaining 44 battery cell groups 1 through 44. The battery sections also contain two temperature sensors, with one sensor located at each end of the section.
The battery energy control module monitors the voltage of the 96 battery cell groups. The voltage sense lines are attached to each inpidual cell group, and these sense lines terminate at a connector located on the top surface of the battery section. A voltage sense harness joins this connector to the battery energy control module.
The battery energy control module contains internal interface control modules that monitor specific cell groups.
The battery energy control module will determine when a fault condition is present. Diagnostics and system status are communicated from the battery energy control module to the hybrid powertrain control module 2 through serial data. The hybrid powertrain control module 2 is the host controller for diagnostic trouble code information.
