Implausible Data Received From Left Impact Pressure Sensor
Table of contents
U1470 RAM Possible Causes
- Faulty Left Impact Pressure Sensor
- Left Impact Pressure Sensor harness is open or shorted
- Left Impact Pressure Sensor circuit poor electrical connection
- Faulty Occupant Restraint Controller (ORC)
How do I fix code U1470 RAM?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the U1470 RAM code
The cost of diagnosing the U1470 RAM code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Air Bag Warning Light ON
U1470 RAM Description
Six side impact sensors are used on vehicles equipped with side curtain airbags, three on each side of the vehicle. One acceleration-type sensor is located behind the B-pillar trim near the base of each B-pillar, and one acceleration-type sensor is located behind the quarter panel trim near the base of each C-pillar. One pressure-type sensor is located on each front poor hardware carrier panel, concealed behind each front door inside the trim panel. The driver door pressure sensor is mounted to the driver inner door panel behind the door trim panel. The impact sensors perform their own self test using power supplied by the Occupant Restraint Controller (ORC) then communicate this status back to the ORC with periodic updates. The repair of this fault condition involves verifying the integrity of the wiring between the ORC and the sensor. The door pressure sensor is hardwired to the Occupant Restraint Controller (ORC).
This code will set, if the ORC and the Driver Door Pressure Sensor (Satellite) do not establish and maintain valid data communications. The Diagnostic Trouble Code (DTC) will become Active after the fault has set for a minimum of 100 milliseconds (ms). The DTC will go to Stored after the ORC to Driver Door Pressure Sensor (Satellite) communication fault has been removed or the suspect pressure sensor has been replaced. The clearing of this fault is immediate upon the suspect internal error being removed or the suspect sensor replaced. The Multifunction Indicator Lamp (MIL) will set in the instrument cluster.
