Anti-Lock Brake System Module Redundant Ground Circuit Open
Table of contents
U2062 FORD Possible Causes
- Faulty Anti-Lock Brake System (ABS) Module
- Anti-Lock Brake System Module harness is open or shorted
- Anti-Lock Brake System Module circuit poor electrical connection
How do I fix code U2062 FORD?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Tech Notes
- There is a Factory Service Bulletin for the following Ford models: 2005-2008 Ford Escape Hybrid. The bulletin recommends cleaning the two ground for the ABS controller. The grounds are located on the right-hand side frame rail under the Hydraulic Control Unit (HCU).
Cost of diagnosing the U2062 FORD code
The cost of diagnosing the U2062 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
U2062 FORD Description
The operating voltage required to supply the ABS module, hydraulic pump, and isolation valves are between 10 and 17 volts. Ignition voltage and battery voltage are supplied to the Anti-Lock Brake System (ABS) Module. The Diagnostic Trouble Code (DTC) will set if no communication is detected with the Anti-Lock Brake System Module.
