‘B’ Camshaft Position Timing Over Retarded Bank 2

Table of contents

P0025 AUDI Possible Causes

  • Faulty Continuously Variable Valve Timing Solenoid
  • Continuously Variable Valve Timing Solenoid harness is open or shorted
  • Continuously Variable Valve Timing Solenoid circuit poor electrical connection
  • Mechanical Defect
  • Valve Timing

How do I fix code P0025 AUDI?

  Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.

Tech Notes

  • There is a Factory Service Bulletin for the following Audi models:
  • 2002–2006 Audi A4
  • 2002–2006 Audi A4 Cabriolet
  • 2002–2006 Audi A6
  • Audi Factory Service Bulletin OBDII Code P0025

Cost of diagnosing the P0025 AUDI code

  The cost of diagnosing the P0025 AUDI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of power
  • Engine rough idle

P0025 AUDI Description

  This fault code is stored in the engine control module when the output from the camshaft position sensor is not as expected. The camshaft position sensor is used to monitor the position of the camshaft. The engine control module uses this information to determine the synchronisation and phasing of the camshaft in relation to the crankshaft. A fault in the variable valve timing and/or valve lift system will generate this fault code.


Leave a Reply

Your email address will not be published. Required fields are marked *