Sensor Reference Voltage ‘A’ Circuit Open
Table of contents
P0641 AUDI Possible Causes
- Faulty Engine Control Module (ECM)
- Engine Control Module harness is open or shorted
- Engine Control Module circuit poor electrical connection
- Shorted sensor on 5 volt circuit
How do I fix code P0641 AUDI?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins.
Cost of diagnosing the P0641 AUDI code
The cost of diagnosing the P0641 AUDI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0641 AUDI Description
This fault code is stored in the Engine Control Module (ECM) when a malfunction occurs with the sensor supply voltage circuit. The Engine Control Module outputs a 5-volt supply voltage to certain sensors. Many components share the same 5-volt supply. If fault codes exist for multiple components that operate with a 5-volt supply the wiring from the Engine Control Module and the Engine Control Module itself should be tested. Also, each component should be disconnected in turn to identify a faulty component pulling down the supply circuit. The Diagnostic Trouble Code (DTC) will set when the Engine Control Module has detected the sensor 5-volt reference circuit voltage is higher or lower than expected.